Ga door naar hoofdinhoud

Come saldare e dissaldare componenti elettrici

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 2 handleidingen die deze stap bevatten.

Stap 18
How To Solder and Desolder Connections: stap 0, afbeelding 1 van 2 How To Solder and Desolder Connections: stap 0, afbeelding 2 van 2
  • Use tweezers to grip the component and remove it.

  • If the leads are stuck but don't have a lot of residual solder, heat the solder pad directly and use tweezers or a spudger to gently remove it.

  • If there is still a lot of solder left on the pad, apply more flux and try using the wick again.

  • Use flush cutters to remove your used wick.

  • When you're done desoldering, refer to this step to clean up your board.

Usa una pinzetta per afferrare il componente e rimuoverlo.

Se i terminali sono bloccati ma non c'è molto stagno residuo, riscalda direttamente la piazzola di saldatura e usa una pinzetta o uno spudger per rimuoverli delicatamente.

Se c'è ancora molto stagno sulla piazzola, applica altro flussante e prova a usare nuovamente la treccia dissaldante.

Usa le tronchesine per rimuovere la treccia dissaldante usata.

Quando hai finito di dissaldare, fai riferimento a questo passo per pulire la tua scheda.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.