Mijn werkbank

Krijg snel toegang tot handleidingen, onderdelen en antwoorden voor jouw apparaten

Mini Digital Oscilloscope DIY Soldering Kit Assembly

Terug naar de handleiding

Engels

Nederlands

Vorige stap Volgende stap

Stap 15 vertalen

Stap 15

Mini Digital Oscilloscope DIY Soldering Kit Assembly, Solder the LED: stap 0, afbeelding 1 van 3

Mini Digital Oscilloscope DIY Soldering Kit Assembly, Solder the LED: stap 0, afbeelding 2 van 3

Mini Digital Oscilloscope DIY Soldering Kit Assembly, Solder the LED: stap 0, afbeelding 3 van 3

Solder the LED

Press the iron's tip against the circuit board's LED solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a small glob of solder on the pad.
Place the LED in the outline labeled LED on the board, with the white (non-green) side aligned with the "+" symbol.
The green markings indicate the negative (-) side.
Solder the LED's first end cap to the board.
The LED's contact pads are underneath it, so the solder joint doesn't need to cover the entire end.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.