Mijn werkbank

Krijg snel toegang tot handleidingen, onderdelen en antwoorden voor jouw apparaten

Logitech G Pro X Superlight Scroll Wheel Board Replacement

Terug naar de handleiding

Engels

Chinees

Vorige stap Volgende stap

Stap 4 vertalen

Stap 4

Logitech G Pro X Superlight Scroll Wheel Board Replacement: stap 0, afbeelding 1 van 3

Logitech G Pro X Superlight Scroll Wheel Board Replacement: stap 0, afbeelding 2 van 3

Logitech G Pro X Superlight Scroll Wheel Board Replacement: stap 0, afbeelding 3 van 3

A small spring holds the right side of the scroll wheel in place. Be careful during this step, as the spring will eject with very little force.
Use tweezers to lift the longer edge of the spring out of its groove and remove the spring.
Installing the spring during reassembly is very tricky and will most likely take multiple attempts—be patient and work slowly. To install the spring, perform the following:
Place the circular part of the spring onto its post so the longer end is closer to the scroll wheel mounting peg.
Guide the short end of the spring into its slot near the rear of the scroll wheel.
Lift the long end of the spring over and into its groove, so it's sitting on top of the scroll wheel mounting peg.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.