Ga door naar hoofdinhoud

Reemplazo de batería Logitech G903

Handleidingsbenodigdheden

Alle vooraf vereiste handleidingen moeten vertaald worden voordat deze vertaling volledig wordt beschouwd.

Cómo apagar un Logitech G903

Reemplazo de los pies del mouse principal Logitech G903

Cómo abrir el Logitech G903

Handleidingsinformatie

= Klaar = Onvolledig
Engels
Spaans
    Use this guide to replace the battery in a Logitech G903 wireless gaming mouse.
    If your battery is swollen, [[What to do with a swollen battery|take appropriate precautions|new_window=true]]. For your safety, ***discharge your battery below 25%*** before disassembling your device. This reduces the risk of a dangerous thermal event if the battery is accidentally damaged during the repair.
    Lithium-ion batteries have a limited lifespan. If your mouse dies quickly and doesn't hold a charge, it may be time to replace the battery.
    This guide requires removing the mouse feet. If you’re planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated for them to be cleanly removed.
    If possible, follow this guide ***after your battery has fallen*** ***below 15% charge***—this is indicated when the LED light on top of the mouse is red. While your G903 has a relatively small battery, any charged battery is a potential safety hazard if accidentally bent or punctured.
    If your battery is swollen, [[What to do with a swollen battery|take appropriate precautions|new_window=true]].
    You might need replacement adhesive to reattach components when reassembling the device.
      If possible, turn on your device and test your repair before installing new adhesive and resealing.
      ***To reassemble your device, follow these instructions in reverse order.***
      Secure the new battery with pre-cut adhesive or double-sided adhesive tape. In order to position it correctly, apply the new adhesive into the device at the places where the old adhesive was located, not directly onto the battery. Press the new battery firmly into place.
      For optimal performance, [[Battery Calibration|calibrate your newly installed battery]] after completing this guide.
      Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
      Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler]].
      For optimal performance, ***calibrate your newly installed battery***: Charge it to 100% and keep charging it for at least 2 more hours. Then use your device until it shuts off due to low battery. Finally, charge it uninterrupted to 100%.

      ***To reassemble your device, follow the above steps in reverse order.***

      Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]].


      Repair didn’t go as planned? Check out our [link|https://www.ifixit.com/Answers/?search=Device/Logitech%20G903_G903|Answers community] for troubleshooting help.

      Stappen

      Stap 1 — Calienta el adhesivo de la batería

      La carcasa de la batería no está en contacto directo con la cubierta exterior del mouse. Debido a eso, es posible que debas repetir el procedimiento de calentamiento un par de veces para aflojar el adhesivo de la batería lo suficiente como para quitar la batería.

      Stap 2 — Retira la batería

      Inserta una púa de apertura en el espacio entre la carcasa de la batería y la batería en el lado opuesto al cable de la batería.

      Stap 3

      Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.