Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden de handleiding die deze stap bevat.
Stap 8 vertalen
Stap 8
-
Remove the following five secrews/standoffs from the DC-to-DC board:
-
One 3 mm Phillips in the lower right corner.
-
Two 3.5 mm Phillips on either side of the battery contacts.
-
One 10 mm Phillips in the upper right corner.
-
One 14 mm long 4 mm standoff in the upper left corner. You can remove this standoff either with a 4 mm nut driver or needlenose pliers.
Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.