Ga door naar hoofdinhoud

iPod Nano 第二代外壳组件更换

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 3 handleidingen die deze stap bevatten.

Stap 4
iPod Nano 2nd Generation Case Assembly Replacement: stap 0, afbeelding 1 van 1
  • Remove the following two screws:

  • One #00 Phillips screw with a large head near the headphone jack.

  • One #000 Phillips screw with a smaller head near the side of the iPod. This screw strips easily, so be sure to press down firmly on the screwdriver.

拆下以下的两颗螺丝:

一个 #00 十字螺丝,在耳机插孔附近

一颗 #000 十字螺丝,其头部较小,靠近 iPod 侧面。 这个螺丝很容易损坏(包括脱落,滑牙等),所以一定要用力压住螺丝刀。

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.