Ga door naar hoofdinhoud

iPhone 6 Plus 배터리 교체

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 5 handleidingen die deze stap bevatten.

Stap 2
iPhone 6 Plus Battery Replacement: stap 0, afbeelding 1 van 2 iPhone 6 Plus Battery Replacement: stap 0, afbeelding 2 van 2
  • Try to keep the strips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of pulling out cleanly.

  • Very slowly, pull and stretch one adhesive strip away from the battery, toward the bottom of the iPhone.

  • Allow the strip to stretch out before pulling any harder. If you can't feel it stretching, ease up, or it will break.

  • Pull at as low of an angle as you can without snagging the adhesive strip on any of the components along the lower edge of the phone.

  • Don't press down on the battery as you pull the strip.

  • The strip will stretch to many times its original length. Continue pulling slowly until it releases and slips out from underneath the battery.

  • If the battery adhesive tabs break during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.

  • If any of the adhesive strips break underneath the battery and cannot be retrieved, try to remove the remaining strips, and then proceed as instructed below.

이 절차를 수행하는 동안 스트립을 평평하고 주름없는 상태로 유지하세요; 주름진 스트립은 깨끗하게 잡아 당겨지지 않고 서로 달라 붙어 파손됩니다.

배터리 접착 탭을 배터리로 부터 iPhone 하단을 향해 매우 천천히 잡아 당기세요.

세게 잡아 당기기 전에, 스트립이 늘어나도록 하세요. 늘어나는 것이 느껴지지 않으면 끊어질 수 있습니다.

접착 스트립이 휴대폰 하단 가장자리 부품들에 걸리지 않을 만큼 최대한 각도를 낮춰서 당기세요.

스트립을 당길때 배터리는 누르지 마세요.

스트립은 원래 길이의 몇 배로 늘어납니다. 배터리 아래에서 분리되어 빠져 나올 때까지 천천히 계속 당기세요.

분리 과정에서 배터리 접착 탭이 끊어진 경우 손가락이나 무딘 핀셋을 사용하여 남은 접착제를 회수하고 계속 당기세요.

배터리 아래에서 접착 스트립이 끊어져서 회수할 수 없는 경우 나머지 스트립을 분리하고 아래 지침에 따라 진행하세요.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.