Logitech MX Ergo zerlegen

Stap 1

Entferne auf der Rückseite sechs Torx T6 Schrauben.

Stap 2

Schiebe ein Hebelwerkzeug in den Spalt unter der rechten Taste und schiebe es den Spalt entlang nach hinten, bis sich die obere Hälfte des Gehäuses löst (mit Clip(s) befestigt).

Stap 3

Carefully lift the top shell.

Stap 4

Lever the scrollwheel sub-assembly free

Stap 5

Unplug the battery from the mainboard, carefully lifting the plug marked red.

Stap 6

Unscrew the bottom left screw holding down the fwd/rev buttons, lifting the assembly to the side

Stap 7

Unscrew the three screws holding the power board i place. Take care not to loose the power switch below as you take the last bits apart.

Stap 8

There you go, all disassembled. Now remove spilled coffee.

Stap 9 — Disassembly of top half

The right click lever comes out after the bracket covering the ribbon cable

Stap 10

Under the circuit boards there is three piece that need to come out next