Open a Saeco Minuto

Stap 1

Disconnect the power plug!

Stap 2

Pry up with a plastic opening tool at the bottom edge of the chrome-plated cover to lift up the coffee dispensing spout. This cover is often very tight, so you have to pry hard and hope that the part does not break.

Stap 3

Remove the Torx T10 screw at the top edge of the coffee dispensing spout.

Stap 4

Lift off the black cover over the coffee dispensing spout. The sliding nozzles will come off at the same time.

Stap 5

Remove both Torx T10 screws on the left and right at the bottom edge of the coffee dispensing spout.

Stap 6

Remove the Torx T20 screw on the finger guard of the grinder. Remove the finger guard.

Stap 7

Remove the three Torx T10 screws under the water tank.

Stap 8

Grab the upper cover on the sides and lift it up.

Stap 9

Remove the water level sensor cable from its brackets.