Onda V80 Plus Touchscreen Replacement

Stap 1 — The slab

Having already removed screen (of the strong way) by removing it from the front and removing pieces of glasses by pieces of glasses. I strongly advise against this method, I have, because of this method, damaged the LCD, the latter being very fragile, be careful. (Blue marks on picture 2)

Stap 2 — The separation

Flip the tablet, try to gently separate the white part on the screen side, and the golden part behind.

Stap 3 — disconnections

After that, be careful not to lose the Power buttons, and Volume +/-

Stap 4 — Takeoff of the slab

Turn the tablet on the screen side, and get an object to generate hot air. A hot air gun would be the perfect tool, but if in the worst case you do not have this, use a hair dryer. If you have an iOpener, it is just as convenient.

Stap 5 —   Place the slab

This step may vary slightly depending on the source of your replacement slab

Stap 6 — reconnections

Then connect the tablecloth, passed through the hole. Reconnect the battery and turn it on to check that the LCD panel and the touch screen are working properly.

Stap 7 — End!

Take the back cover, set up the buttons, and start placing the tablet by the right side. Then, press the tablet all over the edge, and clip all the clips on each edge.