Ga door naar hoofdinhoud
Help
Bewerken van stap 2 —

Stap type:

Sleep om te herschikken

Before removing the hoses, the brake fluid on that caliper should be allowed to drain.

This is done through the bleed screw on each caliper. The following bleed screws are shown:

Front caliper bleed screw

Rear caliper bleed screw

Allow the fluid to drain by loosening the screw just two or three turns until the fluid is dripping quickly. Use a 9mm box end wrench for this job.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.