Repareer je spullen Gemeenschap Winkel

A series of 40 inch LCD HDTVs by Sony.

193 Vragen Bekijk alle

Opties

No picture, no sound, no blinking lights on Sony KDL-40W600B

Cannot turn on with remote or button on TV. Unplugged power brick, waited overnight. Applied power again. Got a brief Sony logo on screen, then it went dark. I have repeated the power disconnect/reconnect several times. Results always the same. No picture (other than the Sony splash screen), no sound and no blinking lights of any kind. I notice that after the splash screen the display has a very dark purple-ish tint until I remove power. Is this a bad board? Any help with which one, if that is the problem? Thanks in advance!

Block Image

Block Image

Block Image

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 1
Voeg een opmerking toe

3 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

@jazzbo "this “after the splash screen the display has a very dark purple-ish tint “ is most likely your backlight being on. This could very well be a mainboard issue. Post some pictures of your boards with your question so we can see what you see. Voeg afbeeldingen toe aan een bestaande vraag

Make sure you have a multimeter so we can check a few things

Was dit antwoord nuttig?

Ja Nee
Score 3

1 Opmerking:

oldturkey03, thanks for the fast response. I’ve added pictures of the 3 boards.

door

Voeg een opmerking toe

Opties

Hi @jazzbo ,

Since you get the splash screen and the unit stays powered on, I'm wondering if it is a software problem rather than a hardware problem. Which would also be on the mainboard where the problem may be as suggested by @oldturkey03

Here's a link showing how to update the firmware in your model TV.

I don't know if it will work if your TV's firmware is a later version or not.

You can contemplate attempting this as a last resort if all else fails to resolve the problem

Was dit antwoord nuttig?

Ja Nee
Score 2

1 Opmerking:

Thanks @jayeff. If all else fails I'll give this a go.

door

Voeg een opmerking toe

Opties

It sounds like you have a faulty LD BOARD. Replace it you are good to go. just for emphasis it is the second picture you uploaded.

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Voeg je antwoord toe

R Foster zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 1

Afgelopen 30 dagen: 14

Altijd: 698