Samsung 58” smart tv model un58h5202afxza . picture when out put new power board in . Now I have picture again . But still have a burn smell so I looked at the new power board and it as a burn on it. Still works .What is causing it to burn a spot on left size of the board .
*
Is dit een goede vraag?
Rep: 4,1k
3
2
Without seeing the actual burn mark, I can’t be 100% sure, but…
In the general case, burn marks often show up around resistors. The excessive heat is due to more current flow that normally anticipated. In your case, it sound like there is a problem where the power board is being asked to produce more power than normal causing excessive heat. Since the original board failed, I would suspect that you have addressed the symptom rather than the problem when you replaced the power supply board. As already suggested, please post a picture of the power board, I would prefer to see both boards (the old defective one as well as the new). These may give us a clue about the true problem.
Dan
Was dit antwoord nuttig?
Rep: 784,3k
1,1k
894
2,3k
rick @dean65
there is no part underneath this board that causes it. What you have here is a bad backlight. You are pulling more current to the backlight causing the traces between the diode and the resistor to get hot enough to melt the board. I am certain that this is the same area where the previous power board failed as well. Unless you replace the backlight array, your power board will fail again.
Measure the voltages on the connector and let us know what you get.
Was dit antwoord nuttig?
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 11
Afgelopen 30 dagen: 18
Altijd: 1,220
2 opmerkingen
@dean65 post a picture with your question of your board and mark the burn on it. Use this guide Voeg afbeeldingen toe aan een bestaande vraag for that. It will allow us to see what you see.
door oldturkey03
Any chance you can snap a photo under that burn mark. I don't see the remnants of a burned part. I suspect that the part that caused this is on the underside of the board.
door Abrsvc