Repareer je spullen Gemeenschap Winkel

Revamped version of the iPhone 3G with faster processing speeds. Repair of this device is similar to the 3G, and requires simple screwdrivers and prying tools. Model A1303 / 8, 16 or 32 GB capacity / black or white plastic back.

1502 Vragen Bekijk alle
Vraag afgerond

Opties

My screen dose not work

My 3GS screen dose not work. When I flip the vibrate switch I get a vibration. Just that the screen dose not work, it stays pitch black. Could this be a problem with the LCD or the connected on the logic board?

Update

I had already taken it apart and I looked at the connectors for the LCD and the connector on the logic board. Here is what they look like. Which one is broken?

Block Image

http://imgur.com/Bd2XEKm,rZIwt3i#0 SCREEN

Block Image

http://imgur.com/Bd2XEKm,rZIwt3i#1 LOGIC BOARD

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0

2 opmerkingen:

This should be a more brighter picture of the logic board. I took it out and gave it a brush. http://imgur.com/xqmWX4O Dose the solder on the side matter?

door

which solder on what side? Looks like bottom left of your logic board connector is not quite right, but difficult to make out.

door

Voeg een opmerking toe

2 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste

Opties

You can check the connectors between the display and the logic board and ensure it's connected by following this guide. If it still doesn't work then it could either be the logic board or the display. The best thing to do at this point is to find a friend with an old 3Gs and swap display! If it works, then the old display is broken. If it doesn't work, then it's the logic board. You can find the display here and the logic board here.

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Opties

Peter Zhao, take a look at the image you posted. The connector from your LCD flex definitely looks like it got all shewed up. Looks like at least 2 contacts that are missing (your image top right corner of the connector." You might want to replace that since it will be easier than the one on your logicboard. That particular image is a bit dark on the right lower corner, but it appears that the contacts are all there.

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe
Weergavestatistieken:

Afgelopen 24 uren: 4

Afgelopen 7 dagen: 10

Afgelopen 30 dagen: 10

Altijd: 241