I recently replaced my failing pump with the ussolarpump 9L (https://www.ussolarpumps.com/catalog/cir...) and fried one of the board's resistors. Turned the cube on (with water and pad plugged in), started smelling smoke, and eventually saw a wisp. I hope I haven't fried the board.

The 9L pump draws .55 amps, whereas the original pump draws .32 amps.

I also replaced the fans, and they seem to run fine, though perhaps they were responsible for the resistor burning out.

Has anyone else run into this issue?

Here's an image of the burned-out resistor (circled in blue):

https://ibb.co/2Y3r28j