Ga door naar hoofdinhoud
Help
Bewerken van stap 7 —

Stap type:

Sleep om te herschikken

At the other end, 2 big flex cables are brought together by a small control board. Disconnect the 2 clips (Green - LCD and Orange - Digitizer) and the other ends of the antennas. Then remove the antenna wires completely.

This small control board is also held down by a little adhesive, but can be carefully pried up.

In the third picture, marked in the Green square, is a piece of plastic that is attached to the board. It is better to just pry it up with the board than disconnect it.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.