Hi all,

i have a Panasonic DMC-FZ1000 II where the LCD screen backlight is not working,

the screen works and can be seen if you tilt the camera to one side but there's no backlighting whatsoever.
I have replaced the driver board and the actual screen, and the connecting cable but still cant get this working, im assuming the motherboard has an issue, does anyone have the pin outs for the screen so i can check if the mother board is sending any voltage out to the screen ?

Hi all,

i have a Panasonic DMC-FZ1000 II where the LCD screen backlight is not working,

the screen works and can be seen if you tilt the camera to one side but there's no backlighting whatsoever.
I have replaced the driver board and the actual screen, and the connecting cable but still cant get this working, im assuming the motherboard has an issue, does anyone have the pin outs for the screen so i can check if the mother board is sending any voltage out to the screen ?

Hi all,

i have a Panasonic DMC-FZ1000 II where the LCD screen backlight is not working,

the screen works and can be seen if you tilt the camera to one side but there's no backlighting whatsoever.
I have replaced the driver board and the actual screen, and the connecting cable but still cant get this working, im assuming the motherboard has an issue, does anyone have the pin outs for the screen so i can check if the mother board is sending any voltage out to the screen ?

speed issue something wrong with one of the governor cables leads to the carb i need to figure out which cable

Microwave door difficult to pull open. Is it a hinge problem or a latch problem?

Microwave door difficult to pull open. Is it a hinge problem or a latch problem?

how do I fix this. I have a black screen and i can hear it booting up but get nothing everyonce in a while I get the screen where I can enter the boot menu or change it but thats it. Ive tried everything reset cmos to taking out the hard drive and still nothing not even anything on an external monitor. help me I dont care if I have to go over the steps a second time Im so willing to try any process

speed issue something wrong with one of the governor cables leads to the carb i need to figure out which cable