/
Mijn werkbank

Krijg snel toegang tot handleidingen, onderdelen en antwoorden voor jouw apparaten

DE
Deutsch
ES
Español
IT
Italiano
PT
Português
TR
Türkçe
JP
日本語
EN
English
FR
Français
NL
Nederlands
RU
Pусский
ZH
中文
KO
한국어
Lid worden
Inloggen

Samsung Galaxy S8 玻璃背板组件更换

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 15 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Chinees
Stap 7
Samsung Galaxy S8 Back Glass Assembly Replacement: stap 0, afbeelding 1 van 2 Samsung Galaxy S8 Back Glass Assembly Replacement: stap 0, afbeelding 2 van 2

  • The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.

  • As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.

  • Use the opening picks to slice through any remaining adhesive and open the phone slightly.

  • If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.

  • During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.

  • Remove the glass from the phone.

指纹传感器线缆与手机在后玻璃面板靠近主摄像头的位置连接。 这个线缆十分的短，在移除玻璃面板的时候也要断开。

抬起玻璃时，请仔细查看以确保带有蓝色连接器的橙色电缆已断开连接。

使用撬片将剩余的粘合剂切开，然后轻轻打开手机。

如果指纹传感器电缆似乎卡住了或还是绷得很紧，不要继续抬起面板，在继续之前请用撬棒的尖端断开连接器。

在重新组装设备的时候，为了重新连接指纹传感器电缆，首先将后盖倾斜到位，直到电缆连接器在其插座上完美对齐。 然后，使用撬棒扁平的一端将连接器笔直按下，轻轻将其卡入到位。

移除玻璃后面板。

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.