Mijn werkbank

Krijg snel toegang tot handleidingen, onderdelen en antwoorden voor jouw apparaten

How to reduce ChiliCube noise level by replacing fans

Terug naar de handleiding

Engels

Nederlands

Vorige stap Volgende stap

Stap 12 vertalen

Stap 12

How to reduce ChiliCube noise level by replacing fans, Attach fan so 3-way switch will reach: stap 0, afbeelding 1 van 2

How to reduce ChiliCube noise level by replacing fans, Attach fan so 3-way switch will reach: stap 0, afbeelding 2 van 2

Attach fan so 3-way switch will reach

If you do go with the 3-speed fan used here, look ahead in instructions to see where the switch gets positioned, then attach fan appropriately to the bracket/shroud plate.
Note direction fan is attached. The side with cable lead-in to motor, (and usually the only label or fancier of the two hub labels), that side faces inward towards the heat sink, and the bracket/shroud plate.
Don't freak out if you think you can't fish the cable through the shroud the right way. You can pass the whole fan through the shroud hole on the 45º.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.