Ga door naar hoofdinhoud

Reemplazo de batería de iPhone de 1.ª generación

Stap 2
iPhone 1st Generation Battery Replacement: stap 0, afbeelding 1 van 1
  • Working from the edge opposite the battery connectors, insert a spudger between the battery and the plastic frame and pry up. The battery is attached to the casing with an adhesive, but should slowly come free.

  • If the battery isn't coming free, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery.

  • Wait about one minute for the alcohol solution to weaken the adhesive.

  • Use the flat end of a spudger to gently lift the battery.

  • Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before continuing.

Trabajando desde el borde opuesto a los conectores de la batería, inserta un spudger entre la batería y el marco de plástico y haga palanca. La batería está unida a la carcasa con un adhesivo, pero debería soltarse lentamente.

Si la batería no se suelta, aplica unas gotas de alcohol isopropílico de alta concentración (más del 90 %) debajo del borde de la batería.

Espera aproximadamente un minuto para que la solución de alcohol debilite el adhesivo.

Utiliza el extremo plano de un spudger para levantar suavemente la batería.

No intentes sacar la batería con fuerza. Si es necesario, aplica unas gotas más de alcohol para debilitar aún más el adhesivo. Nunca deformes ni perfores la batería con tu herramienta de palanca.

Si queda algo de solución de alcohol en el teléfono, límpialo con cuidado o déjalo secar al aire antes de continuar.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.