Ga door naar hoofdinhoud

Reemplazo de la cubierta de la antena del iPhone 1st Generation

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 9 handleidingen die deze stap bevatten.

Stap 3
iPhone 1st Generation Antenna Cover Replacement: stap 0, afbeelding 1 van 1
  • Insert an iPod opening tool in the gap between the antenna cover and the front bezel. The wedge of the tool should be pointing towards the antenna cover. Slide the tool around the corner and up until you reach the metal backing.

  • Repeat the same procedure on the other side of the dock connector.

Inserta una herramienta de apertura de iPod en el espacio entre la cubierta de la antena y el marco frontal. La cuña de la herramienta debe apuntar hacia la cubierta de la antena. Deslice la herramienta alrededor de la esquina y hacia arriba hasta que llegue al soporte de metal.

Repita el mismo procedimiento en el otro lado del conector de la base.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.