Ga door naar hoofdinhoud

開口方法 (1st and 2nd Gen)

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 7 handleidingen die deze stap bevatten.

Stap 6
Opening Procedure (1st and 2nd Gen), Insert an opening pick: stap 0, afbeelding 1 van 3 Opening Procedure (1st and 2nd Gen), Insert an opening pick: stap 0, afbeelding 2 van 3 Opening Procedure (1st and 2nd Gen), Insert an opening pick: stap 0, afbeelding 3 van 3
Insert an opening pick
  • If your screen is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere. Alternatively, very strong tape may be used instead of the suction cup. If all else fails, you can superglue the suction cup to the broken screen.

  • Apply a suction handle to the right edge of the screen, about 5 cm from the bottom edge.

  • Pull up on the suction handle with firm, constant pressure to create a gap large enough to insert an opening pick.

  • Only create a gap small enough to insert an opening pick. Overbending the screen will damage it.

  • Insert the tip of an opening pick into the gap.

  • Don't insert the opening pick more than 5 mm or you'll damage the LCD.

スクリーンがひどく割れている場合は、透明な梱包用テープを貼っておくと、吸盤が固定されることがあります。もしくは吸盤の代わりに非常に強力なテープを使用することもできます。また、吸盤の代わりに強力なテープを使うこともできます。

スクリーンの右端、下端から約5cmのところに吸盤ハンドルを装着します。

吸盤ハンドルを一定の力で引き上げると、オープニングピックを挿入するのに十分な隙間ができます。

オープニングピックを差し込める程度の隙間で十分です。隙間を広げ過ぎると、スクリーンが破損します。

隙間にオープニングピックの先端を差し込みます。

オープニングピックを5mm以上差し込むと、液晶が破損することがありますので、ご注意ください。

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.