Ga door naar hoofdinhoud

Jura Impressa S Model Pump Housing Replacement

Handleidingsbenodigdheden

Alle vooraf vereiste handleidingen moeten vertaald worden voordat deze vertaling volledig wordt beschouwd.

How to open a Jura Impressa S model cover

Jura Impressa S model backpanel

Jura Impressa S Model right-side panel removal

Handleidingsinformatie

= Klaar = Onvolledig
Duits
Engels

      Stappen

      Stap 1

      Unscrew the Torx T15 screw that holds the control board in place.

      Stap 2

      The pump support is like a drawer that can be pulled out to the rear. Two latches hold it in place on the left and right.

      Stap 3

      Pay attention to the diaphragm regulator when pulling it out. You have to push it up a bit so that the whole pump housing can slide out.

      Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.