Ga door naar hoofdinhoud

開口方法

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 10 handleidingen die deze stap bevatten.

Stap 4
Opening Procedure: stap 0, afbeelding 1 van 3 Opening Procedure: stap 0, afbeelding 2 van 3 Opening Procedure: stap 0, afbeelding 3 van 3
  • Heat an iOpener and thread it through the arms of the Anti-Clamp.

  • You can also use a hair dryer, heat gun, or hot plate—but extreme heat can damage the display and/or internal battery, so proceed with care.

  • Fold the iOpener so it lays on the bottom edge of the iPhone.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick into the gap under the screen and the plastic bezel, not the screen itself.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next three steps.

Heat an iOpenerを温めて、リバースクランプのアームの間にこれを通してください。

ヘアドライヤーヒートガンもしくはホットプレートでも対応できますが、過剰な熱はディスプレイや内蔵バッテリーを破損する恐れがあります。取り扱いにはご注意ください。

iOpenerを折り曲げて、iPhoneの下側端に当たるようにします。

1分ほど待機すると、接着剤が剥がれ始め、デバイスの間に隙間ができます。

プラスチックベゼルとスクリーンの間の隙間にオープニングピックを差し込みます。スクリーン自体には差し込まないでください。

クランプで十分な隙間が作れない場合は、さらに接着面に熱を当てて、クランプを1/4程度時計回りに回してください。

一回ごとの作業で1/4以上回さないでください。クランプをまわしたら1分間待ってください。リバースクランプの効果を待ってから、作業を続けてください。

次の3つの手順はスキップしてください。

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.