Ga door naar hoofdinhoud

Procedura di apertura

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 10 handleidingen die deze stap bevatten.

Stap 4
Opening Procedure: stap 0, afbeelding 1 van 3 Opening Procedure: stap 0, afbeelding 2 van 3 Opening Procedure: stap 0, afbeelding 3 van 3
  • Heat an iOpener and thread it through the arms of the Anti-Clamp.

  • You can also use a hair dryer, heat gun, or hot plate—but extreme heat can damage the display and/or internal battery, so proceed with care.

  • Fold the iOpener so it lays on the bottom edge of the iPhone.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick into the gap under the screen and the plastic bezel, not the screen itself.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next three steps.

Scalda un iOpener e fallo passare attraverso i bracci dell'Anti-Clamp.

Puoi usare anche un asciugacapelli, una pistola termica o una piastra calda, ma il calore estremo può danneggiare lo schermo o la batteria interna, quindi procedi con cautela.

Piega l'iOpener così che sia appoggiato sul bordo inferiore dell'iPhone.

Aspetta un minuto per dare la possibilità all'adesivo di lasciarsi andare e creare una fessura.

Inserisci un plettro di apertura sotto lo schermo e la sua scocca di plastica, non solo sotto lo schermo.

Se l'Anti-Clamp non crea una fessura sufficiente, scalda ulteriormente l'area e ruota la manopola di un quarto di giro.

Non girare di più di un quarto di giro alla volta, e aspetta un minuto tra un giro e l'altro. Lascia che l'Anti-Clamp e il tempo lavorino per te.

Salta i prossimi tre passi.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.