Removing and replacing the grinder

Stap 1

Remove the lock washer on the axle for grinding degree adjustment using pliers.

Stap 2

Remove the grinding degree adjustment axle by using pliers to pull it upwards.

Stap 3

Remove the 2 screws on the bean container of the coffee machine with the Torx T10 screwdriver.

Stap 4

Remove the bean container.

Stap 5

Remove the pinion for the grinding degree adjustment.

Stap 6

Remove the 3 screws attaching the grinding mill attachment to the grinder with the Torx T10 screwdriver.

Stap 7

Make sure not to rip any cables in this step.

Stap 8

Disconnect the first connector (black cable) from the plug-in connector attached to the bottom of the grinder.

Stap 9

Separate the second (white) cable attached to the grinder from the housing of the plug-in connector.

Stap 10

Remove the grinder to clean or replace it.

Stap 11

Avoid putting the grinder down completely in this step, but hold it in your hand.

Stap 12

Now set the grinder back into its correct position

Stap 13

Reattach the 3 screws for grinding mill by fastening them to the inserted grinder with the Torx T10 screwdriver.

Stap 14

Reinsert the pinion.

Stap 15

Reinsert the bean container into the coffee machine.

Stap 16

Fasten the two screws we remove from the bean container earlier with the Torx T10 screwdriver.

Stap 17

Reinsert the axle for grinding degree adjustment.

Stap 18

Use pliers to reseat the safety washer.