Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden de handleiding die deze stap bevat.
Stap 2 vertalen
Stap 2
-
In the following steps you will be cutting through the adhesive on the rear glass panel.
-
Take note of the following areas:
-
In addition to cutting around the edge, there is extra adhesive here that should be cut.
-
Avoid sticking the spudger blade in too far here, to avoid damaging the rear button ribbon cable and chip.
Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.