Nerf N-Strike Longshot O-ring Replacement

Vorige stap Volgende stap

Stap 6 vertalen

Terug naar de handleiding

Engels

Nederlands

Stap 6

Nerf N-Strike Longshot O-ring Replacement: stap 0, afbeelding 1 van 2

Nerf N-Strike Longshot O-ring Replacement: stap 0, afbeelding 2 van 2

Remove the screws connecting the plunger tube end cap to the plunger tube using a Phillips #00 screwdriver.
Pull out the plunger to reveal the worn-out O-ring on the plunger head.
When reassembling, a strong spring will increase the risk of stripping the screws and difficulty in reassembly. Use a screwdriver slightly bigger than the slot and push hard into the end cap for the best results.
You can tell if your O-ring is worn-out when it swells past its advertised dimensions, allowing it to sag or slip.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.