Wijzigingen aan stap #1
Bewerken voor Daniel Pawluk —
- Voor
- Na
- Ongewijzigd
Stap regels
| - | [* black] Using the tweezers, gently pull the ribbon from the logic board. |
|---|---|
| + | [* black] Carefully note the brown colored locking bar that shims the ribbon cable in it's housing so it cannot slip. |
| + | [* black] Using a nylon stick (or some other ESD safe probe) ''gently'' push both sides of the locking bar up. |
| + | [* black] Now the ribbon cable should move freely. A careful prod using your nylon spudger should be able to free the cable. ''++This should ***barely*** require any force at all++''. Otherwise, check that the locking bar is fully disengaged. |