Wijzigingen aan stap #20
Bewerken voor Nick Schultz —
Bewerking goedgekeurd door Nick Schultz
- Voor
- Na
- Ongewijzigd
Stap regels
| [* icon_caution] This process is both difficult and time-consuming. ***Take your time*** and ***be extra careful*** not to overheat the solder pads or pins. Avoid using desoldering wick to desolder the leads, as it could easily destroy the pads. | |
| - | [* black] Press the tip against another solder pad and feed the solder wire into the heated area until there's a small |
| + | [* black] Press the tip against another solder pad and feed the solder wire into the heated area until there's a small solder joint on the pin. |
| [* icon_note] Check if any solder unintentionally bridged with a different joint. If so, carefully use your iron to heat the solder between the joints and separate the bridge. If the bridge doesn't want to separate, [guide|173873|desolder it using a desoldering pump|stepid=370734|new_window=true] and try again. Be careful not to overheat the pins or the pads while desoldering. | |
| [* black] Repeat this process for all of the remaining microcontroller pins. |