Wijzigingen aan stap #25
Bewerken voor Nick Schultz —
Bewerking goedgekeurd door Nick Schultz
- Voor
- Na
- Ongewijzigd
Stap regels
| [title] Solder the power inductor | |
| - | [* black] Press the iron's tip against the circuit board's |
| + | [* black] Press the iron's tip against the circuit board's ***L1*** solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a concave pool of solder on the pad. |
| [* black] Re-heat the solder while holding the inductor in its outline, so that its end caps (the sides with the notches) are resting on the circuit board's pads. | |
| [* black] Remove the iron, then remove the tweezers once the solder has cooled. |