Wijzigingen aan stap #4
Stap regels
| [title] Check for shorts | |
| [* black] With a multimeter, check that the pads are not in contact, either from overflowing solder or from loose wires. | |
| - | [* black] If there were any shorts, you might need to reheat the solder to make sure that stays within a single connector, or you might need to cut any wire that |
| + | [* black] If there were any shorts, you might need to reheat the solder to make sure that stays within a single connector, or you might need to cut any wire that would be crossing from one connector to another. |