Prerequisite

Voor het laatst geüpdatet op 20 feb. 2025

Geen schatting

Eenvoudig

Alleen vereisten

Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Inleiding

This is a prerequisite only.

Gereedschap

Use a Torx T3 screwdriver to unscrew the four 3.5 mm Torx T3 screws holding the back plate.
Make sure the screws are kept in a safe place to insure they are not lost.
Remove the back plate.

Gereedschap gebruikt in deze stap:

Tweezers

$4.99

The plastic frame is clipped inside the steel body with four clips, two each on the left and the right side of the watch, near the corners. You can stick a small screwdriver into the cutouts right above the clips and gently lever the plastic frame up, corner by corner.
Once the clips are released, use a pair of tweezers to grab onto the black plastic frame and remove the internal hardware.
Adhesive on the back side of the battery holds the internal components to the front case.
Use tweezers or a plastic opening tool to disconnect the ribbon cable from the motherboard.