Ga door naar hoofdinhoud

A Desktop PC built from off-the-shelf DIY parts, rather than a prebuilt from a major manufacturer. These can also be built by an SI using off-the-shelf parts.

171 Vragen Bekijk alle

Blank screen/No signal

Built a PC. Everything shows it is running. The screen is npt connecting to anything. I have tried different monitors and different setups, different hard drives. No BiOS or anything comes up.

ASUS Prime Z590-P WiFi motherboard

Intel Core i7 11700F processor

GTX PCIe 730 Graphics card

CORSAIR DDR4 16GB RAM

I have reset CMOS. I have taken everything out.

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

1 Antwoord

Hi @familyfun37946,

Is the 16GB memory, 2 modules i.e. 2 x 8GB or one 16GB module? Depending on number of memory modules have you installed them as per p.1-5 of the user manual?

The PC may not be passing POST (power on self test)

Try connecting a system speaker (example only) to the speaker pins on the System Panel connector on the motherboard (see p.1-20 of the manual for location of header and speaker pins) and check for any beep error codes (see beep code table on p.2-19).

Was dit antwoord nuttig?

Score 0

1 Opmerking:

They are two different sticks. They are seated in properly and everything. They even light up.

I will try the speaker test. It did not come with one, so I will have to get one. Thanks!

door

Voeg een opmerking toe

Voeg je antwoord toe

Dreki zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 4

Altijd: 41