Repareer je spullen Gemeenschap Winkel

2616 Vragen Bekijk alle

Opties

Won’t turn on, red light flashes 6 times

My Samsung UN60H6350AF tv just wouldn’t turn on one day. The red light blinks 6 times then stops. There is no sound or picture. My condo does have questionable electricity with possible power surges. I tried to unplug it, hold the power button, wait for a few minutes, then power back on but nothing happened. I have unplugged all other cables from the tv. I think I’m going to need to open it up but need repair/troubleshooting guidance and tips for safety.

Block Image

Block Image

Block Image

Update (08/04/2019)

Ok here are some pics and I have a multimeter. What do I do next?

Block Image

Block Image

Block Image

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 2
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

@ryguy19 yup, time to open it up. This could be a power board or main board issue. since you have no audio or video it is unlikely that this is a bad backlight array. Once open, check the power board connector to the main board for the proper voltages (all are DC) let us know what you find. Samsung does not use post blink codes but this could be a main board issue. Once apart, take a few good pictures and post those with your question so we can see what you see Voeg afbeeldingen toe aan een bestaande vraag

Was dit antwoord nuttig?

Ja Nee
Score 1

9 opmerkingen:

How exactly do I check the power board connector to the main board for the proper voltages? Sorry I’m new to all of this.

door

Once you have your back open post some good pictures of your boards. I will mark where to measure and what voltages to expect. you will need to get/have a multimeter.

door

Ok, I used the multimeter to measure the voltages on the power board. Here is the key and the voltages I measured:

2. UD (2.28v) 1. A13 V (12.82v)

4. BLU_ON (3.26v) 3. A13 V (12.82v)

6. PS_ON (4.46v) 5. A13 V (12.82v)

8. GND (0v) 7. A13 V (12.82v)

10. GND (0v) 9. GND (0v)

door

Those look to be okay. Sounds like your power board is ok which would leave the mainboard as the culprit. Disconnect the wire from the power board to the main board. See if your backlight comes on

door

No backlight when I unplug the wire from the power board to the main board. However, with the cord plugged in I see the red light for the digital audio out(optical) is on (on the main board)and there are 3 blue lights on the T-con board that are on. Does this mean I’m getting power to those two boards? @oldturkey03

door

4 commentaren meer tonen

Voeg een opmerking toe

Voeg je antwoord toe

ryan brown zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 15

Afgelopen 30 dagen: 74

Altijd: 2,625