Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Repair guides and support for top and front loading Whirlpool brand washers.

229 Vragen Bekijk alle

How to fix error code F08 or FOB

Washing machine starts up and after 2 seconds it stops and this code came up. Have to reset the washer cause the door locks. Ive tried various different loads and even a empty load but no luck.

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 5
Voeg een opmerking toe

Essentiële Electronica Toolkit

Kleine toolkit. Grote dromen.

Shop Toolkits


Shop Toolkits

2 Antwoorden

Het nuttigste antwoord

jmears83 , You did not state your model #. This is info i had come up with, F08 indicates that the heater is an open circuit. Check the heater wires for dislodged or burnt wires and check the heater for continuity with a meter.

Check the link below for further info. and view the video. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.

Was dit antwoord nuttig?

Score 2



me i have replace the heater and the ntc at the same time the cable system is ok but the problem still going...what else i have to do???


Voeg een opmerking toe

I have the same problem. Replaced the heater, washer functions normally except for the error at the end of the washing when it shows F08. My brother also had the same issue but his machine was repaired at the shop. Mechanic couldn't figure it out (why it is still showing error) so he reprogrammed control unit just for that…

Was dit antwoord nuttig?

Score 1


ok very usefull info but unfortunally here in company nobody knows how to reprogramming ,,,all says to replace the control unit and my friend this costs money ..(for nothing????).


Voeg een opmerking toe

Voeg je antwoord toe

jmears83 zal eeuwig dankbaar zijn.

Afgelopen 24 uren: 20

Afgelopen 7 dagen: 236

Afgelopen 30 dagen: 1,144

Altijd: 37,541