26 apr. 2020
Deze versie is geschreven door:
jayeff
Tekst:
Hi @trenzterra , Here’s a [https://www.leisto.com/screwdrivrer-bits/phillips-screwdriver-bits/|link] that may help. - I think that a PH00 would be the one to use for 1.2mm when you look at the point size + I think that a PH00 would be OK to use for 1.2mm when you look at the point size
Status:
open
26 apr. 2020
Bewerkt door:
jayeff
Tekst:
Hi @trenzterra , Here’s a [https://www.leisto.com/screwdrivrer-bits/phillips-screwdriver-bits/|link] that may help. + + I think that a PH00 would be the one to use for 1.2mm when you look at the point size
Status:
open
26 apr. 2020
Bewerkt door:
jayeff
Tekst:
Hi @trenzterra , Here’s a [https://www.leisto.com/screwdrivrer-bits/phillips-screwdriver-bits/|link] that may help. - - I think that a PH00 would be the alright to use.
Status:
open
26 apr. 2020
Origineel bericht door:
jayeff
Tekst:
Hi @trenzterra ,
Here’s a [https://www.leisto.com/screwdrivrer-bits/phillips-screwdriver-bits/|link] that may help.
I think that a PH00 would be the alright to use.
Status:
open