Display broken how to change
Screen damaged fully
Weergave:
Toegelaten stemmenIedereen met meer dan 20 reputatie kan problematische opmerkingen en berichten markeren.
Geef details weer
Geef details weer
Rep: 1
Gepost:
hi i too have a problem in my display . a particular area doesnt responds for touch and now the mobile became dead . i dont know how it happened.kindly give me a solution to disassemble blackphone 2 and where could i get touch and display for blackphone 2
Geef details weer
Rep: 85
Gepost:
How can I fix my DVD player that does not turn on?
Rep: 21,9k
Gepost:
There isn't much to go by, but a DVD player is a quite simple device. I think it to be one of three things:
1. Bad cord or power connection. If the cord detaches from the player, make sure there is no debris inside the cord or player. If you can, use a multi meter to test continuity. Also, make sure that outlet is good by plugging other devices into it.
2. Electric problems. The player may have been exposed to static electricity, which could have ruined it. Or, the player was not on a surge protector during a surge. Alternatively, the voltage for the player may be different from what you have in your house. Either 120v or 240v.
3. Power button is broken, which will happen after too much wear and use. If this occurs, it should power on by pressing eject or using the button on the remote.
Hope this helps!
Geef details weer
Geef details weer
Rep: 1
Gepost:
Ok basicly I incorrectly wired an aux port to my car stereo and pluged my nexus into the audio port. Ever since my mic dosnt work and my media volume dosnt work. My speakers will work if the phone is rang but not if I play music etc. If I use headphones I can hear media volume and also use the mic on the headphones. I'm not sure if I've destroyed the headphone port with stray voltage from stereo or if the phone is stuck in headset mode any ideas people!!??
Geef details weer
Gepost:
Hello,
I was repairing an iPhone 5 today. When I joined everything together I tested the screen and everything looked fine. I then left the screen turned on, but when I start putting the screen in the frame to secure it, the LCD image suddenly disappears but the backlight stays on. Turning the phone on/off still works at that point so it's a screen related issue I think.
When I lift the screen up again, and press the power button twice to go in and out of stand-by, the screen works again, and I can reproduce the above process.
I don't know what to do, as soon as I try to put the phone together, the LCD image stops working! Is my screen faulty?
Is this a known problem? I can't seem to find it on Google.
Willem.
Geef details weer
Rep: 133
Gepost:
The phone fired up fine, but the touch screen is not working now. What did I do wrong?
Geef details weer
Rep: 1
Gepost:
I got a 2005 cavalier 2.2. The starter and battery have been replaced new. Not check engine lights. Car has been running great since the starter was changed. Since it got cold below 75 degrees Celsius the car no longer starts or cranks. I've checked the pcm for corrosion. I've checked all the fuses. Any thoughts?
JackoAllMasteroNone @jackoallma91941
Rep: 259
Gepost:
Check all your grounds for corrosion. Take them off, clean surfaces and re-install. Use a voltage meter and check volts to battery and starter before and while trying to crank it over. Also check continuity between starter and ground while trying to crank it over. be careful not to touch anything metal to positive and ground at the same time. PS: 12volt car battery will not shock you. voltage at battery and starter is safe to touch...but once it goes through the coils beware...then it can shock you. If you touch metal to both positive and ground/negative at the same time it can and will spark and arc...like welding...it can burn you and can be very dangerous. please take necessary caution.
Geef details weer
Rep: 13
Gepost:
Hi I have a BenQ xbox360 drive and It did not work so I replaced the laser. Now when I put a game in it it says Play dvd. The lense it clean. What do I do?
Geef details weer
Rep: 25
Gepost:
Hi,
I dropped my 'WD My Book 1230 - 4TB'. It didn't break at all. The USB got pulled out, once I reconnected, it worked fine for a couple of minutes, it was playing a song, which stopped midway, the I tried to reconnect it and the song continued from where it stopped, after the song ended, the HDD was no longer detecting the remaining files, the HDD was connected to my T.V. when it fell.
After all of the above, I tried to connect it to my laptop and it didn't read at all, didn't show up on 'My Computer', tried reconnecting a few times, but it wouldn't read at all.
It has very important files in it, please help me find a solution to fix the HDD without losing any data.
The disk's light is on as usual, and it seems to be running from the sound. It did try to show up on 'My Computer' after a few times connecting and disconnecting, but didn't happen.
Avi.
Oeps! Ik zou graag mijn mening herzien.
Uitvouwen / Samenvouwen
Goedkeuren
Omhoog
Afkeuren
Omlaag
Open Help