Repareer je spullen Gemeenschap Winkel

基础 LED 手电筒 DIY 焊接套件组装

Terug naar de handleiding
Engels
Chinees
Stap 20
Basic LED Flashlight DIY Soldering Kit Assembly, Insert the LED: stap 0, afbeelding 1 van 3 Basic LED Flashlight DIY Soldering Kit Assembly, Insert the LED: stap 0, afbeelding 2 van 3 Basic LED Flashlight DIY Soldering Kit Assembly, Insert the LED: stap 0, afbeelding 3 van 3
Insert the LED

  • The LED is NOT symmetrical and must be oriented correctly.

  • Insert the LED leads about halfway into the front of the board, with the longer leg in the hole labeled "Long Leg," and the shorter leg in the hole labeled "Short Leg."

  • One edge of the LED's clear epoxy lens is flat instead of round. This flat edge indicates the negative (-) lead.

  • Push the LED towards the board (bending the leads) so the lens fits in the notch between the words "Let Your" and "Light Shine" on the top/front of the circuit board.

插入 LED

LED 不对称，必须正确定位。

将 LED 引线插入电路板正面约一半的位置，较长的脚插入标有“长脚”的孔中，较短的脚插入标有“短脚”的孔中。

LED 透明环氧树脂透镜的一边是平的，而不是圆的。这个平边表示负极 (-) 引线。

将 LED 推向电路板（弯曲引线），使镜头适合电路板顶部/正面的“Let Your”和“Light Shine”字样之间的凹槽。

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.