Ga door naar hoofdinhoud

Procedimiento de apertura

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 10 handleidingen die deze stap bevatten.

Stap 4
Opening Procedure: stap 0, afbeelding 1 van 3 Opening Procedure: stap 0, afbeelding 2 van 3 Opening Procedure: stap 0, afbeelding 3 van 3
  • Heat an iOpener and thread it through the arms of the Anti-Clamp.

  • You can also use a hair dryer, heat gun, or hot plate—but extreme heat can damage the display and/or internal battery, so proceed with care.

  • Fold the iOpener so it lays on the bottom edge of the iPhone.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick into the gap under the screen and the plastic bezel, not the screen itself.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next three steps.

Calienta un iOpener y pásalo por los brazos del Anti-Clamp.

También puedes utilizar un secador de pelo, una pistola de calor o una plancha caliente, pero el calor extremo puede dañar la pantalla y/o la batería interna, así que procede con cuidado.

Dobla el iOpener de forma que quede sobre el borde inferior del iPhone.

Espera un minuto para que el adhesivo se despegue y se abra el hueco.

Inserta una púa de apertura en el hueco que hay debajo de la pantalla y el bisel de plástico, no en la propia pantalla.

Si el Anti-Clamp no crea un hueco suficiente, aplica más calor en la zona y gira la manivela un cuarto de vuelta.

No gires la manivela más de un cuarto de vuelta cada vez y espera un minuto entre giro y giro. Deja que el Anti-Clamp y el tiempo hagan el trabajo por ti.

Omite los tres pasos siguientes.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.