Ga door naar hoofdinhoud

Procedimiento de apertura

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 13 handleidingen die deze stap bevatten.

Stap 4
Opening Procedure: stap 0, afbeelding 1 van 2 Opening Procedure: stap 0, afbeelding 2 van 2
  • Heat an iOpener and thread it through the arms of the Anti-Clamp.

  • You can also use a hair dryer, heat gun, or hot plate—but extreme heat can damage the display and/or internal battery, so proceed with care.

  • Fold the iOpener so it lays on the bottom edge of the iPhone.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick under the screen when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next three steps.

Calienta un iOpener y colócalo entre las abrazaderas del Anti-Clamp.

Puedes usar una secadora de cabello, pistola de calor, o una placa caliente — pero el calor extremo puede dañar el display y/o batería interna, así que procede con precaución.

Dobla el iOpener para que se apoye sobre el borde inferior del iPhone.

Espera un minuto para que el adhesivo se suelte y se abra un hueco.

Inserta una púa de apertura debajo de la pantalla cuando el Anti-Clamp cree un hueco lo suficientemente grande.

Si el Anti-Clamp no crea una grieta suficiente, aplica más calor en la zona y gira el mango un cuarto de vuelta.

No uses más de un cuarto de giro y siempre espera un minuto después de cada giro de la manija. Deja que el Anti-Clamp haga su trabajo con un poco de margen de tiempo.

Omite los siguientes dos pasos.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.