-
Insert an opening pick in to the gap between the battery housing and the battery at the side opposite to the battery cable.
-
Slide the opening pick under the battery and lift up to pry the battery off of its housing.
-
Make sure you push underneath the battery and not into it. Take care not to puncture or bend the battery with your tool—a punctured or bent battery may leak dangerous chemicals or cause a thermal event.
-
In case you have trouble prying up the battery with an opening pick, you can try to use a spudger instead as seen in this picture. When working with a spudger take extra care not to bend the battery.
-
If you encounter significant resistance, pause and heat the adhesive further.
-
Remove the battery.
-
Do not reuse the battery after it has been removed, as doing so is a potential safety hazard. Replace it with a new battery.
-
It is likely you can reuse the old adhesive with the new battery. If you wish to replace the adhesive instead, remove the old adhesive and wipe away any adhesive residue with a lint-free cloth and high-concentration isopropyl alcohol.
Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.
Sneltoetsen voor het Bewerken van Handleiding-Stappen:
Ctrl + Shift + N
Voeg hieronder een nieuwe regel toe
Ctrl + Shift + P
Voeg hierboven een nieuwe regel toe
Ctrl + ]
Huidige regel laten inspringen
Ctrl + [
Maak het inspringen van deze regel ongedaan
Ctrl + D
Huidige regel verwijderen
Shift + ;
Navigeer naar de volgende stap.
Shift + H
Navigeer naar vorige stap.
Bekijk alle snelkoppelingen
