Protocol Dronium III AP Light Bulb Replacement - iFixit reparatiehandleiding

Word lid van de reparatiegemeenschap - Account aanmaken

Inleiding

This guide provides instructions for the removal and re-installation of the drone L.E.D. bulbs. This guide requires soldering. Please see this guide for more information on how to solder and desolder connections.

Wat je nodig hebt

1. Stap 1 Drone Battery Pack
  Ensure the drone is powered off.
  
  Press in and lift battery compartment cover.
  
  A soft pry tool may be used for easier access.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
2. Stap 2
  Remove battery pack from body of drone.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
3. Stap 3
  Disconnect white connectors between the battery pack and drone.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
1. Stap 4 L.E.D. Bulb(s)
  Remove the eight (8) 5mm Philips screws attaching the motor arms to the body using a Philips J00 screwdriver.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
2. Stap 5
  Remove the six (6) 5mm Philips screws attaching the Body Cover to the Body of the drone using a Philips J00 screwdriver.
  
  Remove the Body Cover.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
3. Stap 6
  Remove the two (2) 5mm Philips screws attaching the Motherboard to the body of the drone using a Philips J00 screwdriver.
  
  Lift the Motherboard off the mounting position.
  
  Do not pull hard on the Motherboard as solder connections are fragile.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
4. Stap 7
  This step contains a tool that can present a potential burn hazard.
  
  Prepare and warm up a soldering iron.
  
  Position Motherboard so that the L.E.D. bulb solder joints are accessible.
  
  Use the soldering iron to melt the solder joints.
  
  For more detailed instructions on how to solder, visit out How to Solder and Desolder Connections guide.
  
  Remove the L.E.D. bulb from the Motherboard
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024

Conclusie

To reassemble your device, follow these instructions in reverse order.

Annuleren: ik heb deze handleiding niet afgemaakt.

Auteur

met 4 andere bijdragers

Steven Mooers

Lid sinds: 10/18/17

401 Reputatie

4 handleidingen geschreven

Team

UW Tacoma, Team S1-G1, Rose Fall 2017 Lid van UW Tacoma, Team S1-G1, Rose Fall 2017

UWT-ROSE-F17S1G1

4 Leden

4 handleidingen geschreven

0Gids Commentaar

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 16

Altijd: 416