Logitech M125 Power Cord Replacement

Inleiding

If your Logitech M125 cord has stopped retracting or no longer transmits data, use this guide to help replace the cord.

The power cord provides connectivity and mouse movement.

If you are having issues getting the mouse to connect properly, or the cord will not retract anymore, consider visiting the M125 troubleshooting page before replacing the part: Logitech M125 Troubleshooting

Be sure to unplug your mouse before proceeding with this guide.

Wat je nodig hebt

Stap 1 Button Plate

Logitech M125 Power Cord Replacement, Button Plate: stap 1, afbeelding 1 van 3

Logitech M125 Power Cord Replacement, Button Plate: stap 1, afbeelding 2 van 3

Logitech M125 Power Cord Replacement, Button Plate: stap 1, afbeelding 3 van 3

Turn the device over and remove the two 0.5mm screws near the front of the mouse by using a Phillips #0 screwdriver.
The black screws used in the Logitech M125 frame are all the same size and do not need special consideration for keeping them separated. Silver colored screws are used on the circuit board and have broader heads.
Once the screws are removed, open the mouse from the front as it pivots at the rear.

Bewerken

Stap 2

Once the mouse is opened, remove the two black 0.5mm screws located towards the back of the mouse. These are the retention screws for the mouse button plate.
These screws will also require the Phillips #0 screwdriver.

Bewerken

Stap 3

Logitech M125 Power Cord Replacement: stap 3, afbeelding 3 van 3

There are two tabs that further secure the mouse buttons to the frame. They are located on either side of the mouse cord retracting mechanism.
The tighter confines of the mouse interior will be easier to navigate with metal prying tools. While plastic tools are preferred for most plastic devices, they are too large to access the left tab in the picture.
To dislodge the tabs, use a prying tool while pressing down on the back of the mouse. When prying, push the tab towards the outside of the mouse.

Bewerken

Stap 4

To finish removing the button plate, continue lifting the rear of the plate until the tabs have fully left their slots.
Once the tabs are clear, push the plate towards the front of the mouse and lift.

Bewerken

Stap 5

The mouse button plate has now been fully removed. In order to install the replacement, follow the instructions for this guide in reverse.

Bewerken

Stap 6 Power Cord

Logitech M125 Power Cord Replacement, Power Cord: stap 6, afbeelding 1 van 2

Logitech M125 Power Cord Replacement, Power Cord: stap 6, afbeelding 2 van 2

Using a Phillips #0 screwdriver, unscrew the three black 0.5mm screws from the frame to remove the power cord housing
Set mouse plate aside after unscrewing the cord housing from the plate

Bewerken

Stap 7

Logitech M125 Power Cord Replacement: stap 7, afbeelding 3 van 3

Unscrew the silver 0.25mm screws to remove the circuit board from the mouse base with the same screwdriver.
Once unscrewed, remove the circuit board.
Circuit board needs to be lifted from the front before being pulled forward to remove it

Bewerken

Stap 8

The cable is soldered into the board and will require a soldering iron to replace.
To continue further, please refer to the following guide on how to solder connectors: Hoe moet je (de-)solderen?.
Follow these steps in reverse to reassemble the mouse.