Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Inleiding

Learn how to properly replace the power cable of your Comfort Zone CZ6C.

  1. Make sure to unplug the Comfort Zone CZ6C before cutting any wires. Before attempting to replace your power cable, learn how to solder using the How To Solder and Desolder Corrections Guide. Start with the fan on its back. Unscrew the back panel to expose the internal wiring.
    • Make sure to unplug the Comfort Zone CZ6C before cutting any wires.

    • Before attempting to replace your power cable, learn how to solder using the How To Solder and Desolder Corrections Guide.

    • Start with the fan on its back. Unscrew the back panel to expose the internal wiring.

  2. Unscrew the yellow cap that connects the black wire and the gray power cord wire. Then, unwind the tied wires and pull them apart. Unscrew the yellow cap that connects the black wire and the gray power cord wire. Then, unwind the tied wires and pull them apart. Unscrew the yellow cap that connects the black wire and the gray power cord wire. Then, unwind the tied wires and pull them apart.
    • Unscrew the yellow cap that connects the black wire and the gray power cord wire. Then, unwind the tied wires and pull them apart.

  3. LCD iPhone-scherm fixkits

    De goedkope optie, ondersteund door onze levenslange garantie.

    Koop kits

    LCD iPhone-scherm fixkits

    Bespaar op reparatiekosten, niet op kwaliteit.

    Koop kits
  4. Remove the plastic cover on the switch by pulling it apart from the back panel. Remove the plastic cover on the switch by pulling it apart from the back panel.
    • Remove the plastic cover on the switch by pulling it apart from the back panel.

  5. Use the soldering iron with caution. Don't touch the tip of the soldering iron to avoid the risk of injury.
    • Use the soldering iron with caution. Don't touch the tip of the soldering iron to avoid the risk of injury.

    • This step can be made easier with the help of a partner to hold the wiring while you desolder the connection.

    • Disconnect the gray power wire from the switch by desoldering the connection.

  6. Strip the end of the gray power cord.
    • Strip the end of the gray power cord.

    • Then solder the end of the gray power cord to the switch.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Nishanth Dara

Lid sinds: 08-04-15

135 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 17-5, Forte Spring 2015 Lid van Cal Poly, Team 17-5, Forte Spring 2015

CPSU-FORTE-S15S17G5

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 4

Afgelopen 30 dagen: 15

Altijd: 1,418