Word lid van de reparatiegemeenschap - Account aanmaken

Inleiding

This guide will help your install a new driver.

Wat je nodig hebt

1. Stap 1 Speaker Assembly
  Remove the ear pads by peeling them away from the grill.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
2. Stap 2
  Remove all four 1cm screws on the inside of the headphone using a #1 Phillips head.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
3. Stap 3
  Remove the speaker from the grill by pulling it out.
  
  Remove the speaker carefully so you do not rip the wires out.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
1. Stap 4 Driver
  With a #0 phillips head, unscrew the three, 1 cm screws which are holding the driver (red wafer) in its bracket.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
2. Stap 5
  Pull the driver out of its bracket.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
3. Stap 6
  Remove the two wires, red and yellow, by de-soldering them from the driver using a soldering iron and desoldering wick. Reference Hoe moet je (de-)solderen?.
  
  The areas where you solder will be hot so wait until the solder joints are cool before handling the wires again.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024
4. Stap 7
  Connect the existing wires to the new driver by re-soldering the wires using the soldering iron.
  
  Using the copper as a reference, re-solder the yellow wire to the top left solder joint and the red to the bottom left solder joint.
  
  The areas where you solder will be hot so wait until the solder joints are cool before handling the wires again.
  Vertaal
  
  Vraag FixBot
  
  Voeg opmerking toe
  
  1024