Repareer je spullen Gemeenschap Winkel

3533 Vragen Bekijk alle

Opties

GE GTW331BMRWS- Slight leak/odd noise/ flashing lights on interface/

The issue happened at the end of the cycle. The washer did not drain, but it indicated that the cycle was complete.

Some water had leaked onto the floor. It also was flashing lights on the interface. My wife has indicated to me that she unplugged it and tried to plug it back in to retry the cycle but now makes an "odd" noise. I have been unable to get home and see the issue for myself.

However this issue continues to persist.

It is leveled and not overfilled. The device is about two years old and was bought new. Hopping for some ideas so I can start trouble shooting (or shopping)

Thanks.

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0

1 Opmerking:

Further, now there are no lights at all.

door

Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste

Opties

You don't want to shop after only 2 years.

You need to understand the block diagram of a washer. The water must be pumped out, therefore there is a pump to do that. You must disassemble the unit and find the pump and inspect it. If it is leaking, then I would suspect either a bad seal or a cracked pump housing. There could also be a sock or other small item in the pump. It has happened to me.

Was dit antwoord nuttig?

Ja Nee
Score 0
Voeg een opmerking toe

Voeg je antwoord toe

bradK zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 20