Repareer je spullen Gemeenschap Winkel

The Kenmore 110 Series is an easy to use home Washing machine created by Kenmore.

497 Vragen Bekijk alle

Opties

My Kenmore 110 washer will only fill under the rinse and spin setting.

My Kenmore washer will not fill. It does fill on rinse and spin setting, which I tried after watching a YouTube video. My understanding from the video was that this meant it was either a timer or temperature switch. But the video didn't line up with my washer, it was for an older type of unit. I've been trying to figure it out by looking at YouTube videos but to no avail so far. Any advice is appreciated. Thanks

Update (08/29/23)

Model number is 110.22352511.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 1
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

Hi @ericwillia96978

Wonder if it is a problem with the hot water supply or the hot water inlet solenoid in the washer.

Hot and cold water can be used for the wash cycle but cold water only is used for the rinse cycles

Check that the hot water supply to the machine is 120°F (49°C).

If the hot water supply temperature is OK here's the tech sheet for the washer.

Run the diagnostic tests as shown on p.4 (see Automatic test mode) and check if any error codes are being displayed.

See the Fault/Error Code Display Method chart on p.3 for how to interpret the status LEDs if any codes are shown.

The meaning of the code and the possible causes are shown on p.6-p.7

Was dit antwoord nuttig?

Ja Nee
Score 2
Voeg een opmerking toe

Voeg je antwoord toe

Eric Williams zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 12

Altijd: 73