Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Vragen Bekijk alle

Opties

Apple Logo Bootloop, no Recovery or DFU, doesn't register any inputs

This iPhone 6 bootloops, takes no button inputs (power or home). Just bootloops until the battery is empty. I'm quite certain it must be a hardware issue, but how do I figure out what's causing it? Dead NAND? No Recovery software, iTunes and DFU works. The home button isn't in the screen frame as that is completely shattered, maybe I'm just $@$* at pressing it outside its mounting position. Any suggestions on what could be wrong, I can microsolder, just need to know what (who would've thought).

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

3 Antwoorden

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

possibly a tristar issue

Was dit antwoord nuttig?

Ja Nee
Score 2

2 opmerkingen:

That could make sense, but the phone still charges, gonna give it a try.

door

@Karl Wünsche So the thing about Tristar is, it’s not actually for charging. It’s mostly for USB function, it just gets caught up in the crossfire a lot because it’s what identifies what’s plugged into the lightning port. I’d say tristar is a reasonable start if you’ve already narrowed it down to a board issue.

door

Voeg een opmerking toe

Opties

Before jumping straight to a board issue make sure it’s not a bad part. But it into a known good housing, or good parts if you have any. At the very least see what it does when only the essentials are connected (something so you can tell it’s booting and something to prompt it to boot. Usually I just leave the dock flex, display (no front camera) and battery connected and see what it does then.

Could absolutely be a board issue, but lots of things cause bootloop. After doing tristar, that’s where I would check what the power readings look like on DC power supply (assuming you have one and way to connect it to the battery connector on the iPhone board) and/or start diode moding connectors with a multimeter.

Was dit antwoord nuttig?

Ja Nee
Score 1
Voeg een opmerking toe

Opties

Try it without the front camera ribbon connected and plug in the charger before trying to turn it on. Front Camera can cause boot loops but so can a bad battery. You can buy aftermarket home buttons cheap enough. Only function you'll lose is fingerprint id.

Was dit antwoord nuttig?

Ja Nee
Score 0

1 Opmerking:

Bought a new battery and home button, didn't have the front camera connected. Only logic board, battery, screen and home button, aswell as the charging ribbon.

door

Voeg een opmerking toe

Voeg je antwoord toe

Karl Wünsche zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 49