Major components (bottom cover, battery, wheels, brush assembly) are easy to remove & replace. However, I believe I need to clean connections at the main board below the top cover to repair my Roomba. I don’t see an obvious way to get the cover off. Any help?
Is dit een goede vraag?
Rep: 813,5k
1,2k
920
2,4k
@potterra you need to remove the bumper. Then disconnect the ribbon cable from the bumper before you remove it completely. Take a look at this video and use that as a general guide since it is not the same model as yours.
Was dit antwoord nuttig?
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 4
Afgelopen 30 dagen: 14
Altijd: 400
